Cisco SCE2020-4XGBE-SM - How to Remove One SNTP Server; How to Define the SNTP Unicast Update Interval; Defining the SNTP Unicast Update Interval: Example; Options

5-66
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configure SNTP
How to Remove One SNTP Server
Options
The following option is available:
• ip-address — the IP address of the SNTP unicast server.
Step 1 From the SCE(config)# prompt, type no sntp server ip-address and press Enter
Removes the specified SNTP unicast server.
How to Define the SNTP Unicast Update Interval
• Options, page 5-66
• Defining the SNTP Unicast Update Interval: Example, page 5-66
Options
The following option is available:
• interval — the time in seconds between updates (64 through 1024)
default interval = 900 seconds
Step 1 From the SCE(config)# prompt, type sntp update-interval interval, and press Enter.
Configures the SNTP unicast client to query the server at the defined intervals.
Defining the SNTP Unicast Update Interval: Example
The following example shows how to set the SNTP update interval for 100 seconds.
SCE(config)# sntp update-interval 100
How to Display SNTP Information
Step 1 From the SCE> prompt, type show sntp, and press Enter.
Displays the configuration of both the SNTP unicast client and the SNTP multicast client.