Cisco SCE2020-4XGBE-SM - Displaying Subscriber Information

9-23
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Monitoring Subscribers
How to display subscribers with no mapping
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping none and press Enter.
How to display the number of subscribers that are mapped to a specified VLAN ID
Options
The following options are available:
• VLAN-id — VLAN ID to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount mapping VLAN-id
VLAN-id and press Enter.
How to display the number of subscribers with no mapping
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount mapping none and
press Enter.
Displaying Subscriber Information
• How to display a listing of subscriber properties, page 9-24
• How to display complete information for a specified subscriber, page 9-24
• How to display values of subscriber properties for a specified subscriber, page 9-24
• How to display mappings for a specified subscriber, page 9-25
• How to display OS counters for a specified subscriber, page 9-25
You can display the following information about a specified subscriber:
• values of the various subscriber properties
• mappings (IP address, VLAN-ID or MPLS/VPN)
• OS counters:
– current number of flows
– bandwidth