9-38
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Configuring Subscriber Aging
How to Restore the Configured Capacity Option
Step 1 From the SCE(config if)# prompt, type subscriber capacity-options enable and press Enter.
Step 2 Load the new application.
How to Monitor the Maximum Number of Subscribers
Use this command to see the configured maximum number of subscribers and whether the capacity
options are in effect or have been overridden.
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber max-subscribers and press Enter.
Configuring Subscriber Aging
• How to Enable Aging for Anonymous Group Subscribers, page 9-38
• How to Enable Aging for Introduced Subscribers, page 9-39
• How to Disable Aging for Anonymous Group Subscribers, page 9-39
• How to Disable Aging for Introduced Subscribers, page 9-39
• How to Set the Aging Timeout Period for Anonymous Group Subscribers, page 9-39
• How to Set the Aging Timeout Period for Introduced Subscribers, page 9-40
• How to Display Aging for Anonymous Group Subscribers, page 9-40
• How to Display Aging for Introduced Subscribers, page 9-40
As explained previously (Aging Subscribers, page 9-5, aging is the automatic removal of a subscriber
when no traffic sessions assigned to it have been detected for a certain amount of time. Aging may be
enabled or disabled, and the aging timeout period (in minutes) can be specified.
Aging can be configured separately for introduced subscribers and for anonymous subscribers.
Use the following commands to configure and monitor aging.
• [no] subscriber aging
• subscriber aging timeout
• show interface linecard 0 subscriber aging
How to Enable Aging for Anonymous Group Subscribers
Step 1 From the SCE(config if)# prompt, type subscriber aging anonymous and press Enter.
To Next Page
Loading...
