Cisco SCE2020-4XGBE-SM - How to Remove a Specific Subscriber; Options; How to Remove All Introduced Subscribers

9-11
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Removing Subscribers and Templates
Use the following commands to remove all subscribers, anonymous groups, or subscriber templates from
the system.
• no subscriber all
• no subscriber anonymous-group all
• clear subscriber anonymous
• default subscriber template all
Use the following commands to remove a specific subscriber or anonymous group from the system.
• no subscriber name
• no subscriber anonymous-group name
These subscriber management commands are LineCard interface commands (with the exception of the
clear subscriber anonymous command, which is a Privileged Exec command). Make sure that you are
in LineCard Interface command mode, and that the SCE(config if)# prompt appears in the command line.
How to Remove a Specific Subscriber
Options
The following option is available:
• subscriber-name — the name of the subscriber to be removed
Step 1 From the SCE(config if)# prompt, type no subscriber name subscriber-name and press Enter.
Removes the specified subscriber.
How to Remove All Introduced Subscribers
Step 1 From the SCE(config if)# prompt, type no subscriber all and press Enter.
Removes all introduced subscribers.