8-6
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 8 Raw Data Formatting: The RDR Formatter and NetFlow Exporting
Configuring Data Destinations and Categories
Protocol
The following two protocols are supported:
• The RDR Formatter: the Service Control proprietary protocol
• NetFlow V9: an industry standard protocol
These two protocols can be used simultaneously in the same deployment. However, each destination can
support only one protocol.
Transport Type
The following two transport types are available:
• TCP
• UDP
Currently, the transport type is linked to the configured protocol as follows:
• RDRv1 protocol requires TCP transport type
• NetFlow V9 protocol requires UDP transport type
Configuring Data Destinations and Categories
• Configuring a Data Destination, page 8-6
• Configuring the Data Categories, page 8-8
• Configuring the Forwarding Mode, page 8-12
Configuring a Data Destination
• Options, page 8-7
• Configuring the Data Destinations: Examples, page 8-7
There are three general categories of CLI commands related to the configuration of data destinations:
• General commands that apply to both the RDRv1 protocol and the NetFlow protocol
• Commands that are relevant only to the RDR formatter (may affect NetFlow exporting as well)
• Commands relevant only to the NetFlowV9 protocol and the NetFlow exporting support
To Next Page
Loading...
