12-46
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
VAS over 10G
VAS Over 10G Sample Configuration
Following is a sample illustrating the steps in configuring the VAS over 10G solution.
Command Purpose
Step 1
SCE#configure
SCE(config)# interface LineCard 0
Enters LineCard Interface configuration mode
Step 2
SCE(config if)#VAS-traffic-forwarding health-check
topology MGSCP
Sets the VAS health-check to MGSCP mode.
Step 3
SCE(config if)# VAS-traffic-forwarding health-check
ip-address source 192.168.100.0:0xffffff00 destination
192.168.101.0
Set the VAS health-check source and destination IP
addresses
(source = 192.168.100.0/24 and destination =
192.168.101.0)
Step 4
SCE(config if)# VAS-traffic-forwarding traffic-link
auto-select
Set the VAS traffic link to auto-select so in case of a
failure in any of the VAS servers group, the VAS
traffic link will be automatically switched.
Step 5
SCE(config if)# VAS-traffic-forwarding traffic-link
auto-select link-switch-delay 240
Configure the link switch delay (four minutes).
The delay will be applied only if there was no
successful health check on the current link.
Step 6
SCE(config if)# #VAS-traffic-forwarding traffic-link
auto-select initial-selection link-0
Set link-0 to be used as the initial VAS traffic link in
auto-select mode.
Step 7
SCE(config if)#VAS-traffic-forwarding VAS server-id 0
VLAN 600
SCE(config if)#VAS-traffic-forwarding VAS server-id 1
VLAN 601
SCE(config if)#VAS-traffic-forwarding VAS server-id 2
VLAN 602
SCE(config if)#VAS-traffic-forwarding VAS server-id 3
VLAN 603
Assign VAS servers 0-3 to VLAN 600-603
respectively.
Step 8
SCE(config if)#VAS-traffic-forwarding VAS server-group
0 server-id 0
SCE(config if)#VAS-traffic-forwarding VAS server-group
0 server-id 1
SCE(config if)#VAS-traffic-forwarding VAS server-group
1 server-id 2
SCE(config if)#VAS-traffic-forwarding VAS server-group
1 server-id 3
Map VAS servers 0-1 and 2-3 to server groups 0 and
1 respectively, allowing server redundancy within
each group.
Step 9
SCE(config if)#VAS-traffic-forwarding Set the SCE platform to forward VAS traffic (enable
VAS traffic forwarding).
To Next Page
Loading...
