Cisco SCE2020-4XGBE-SM - How to Configure the Duplex Operation of the Management Interface; How to Configure the Speed of the Management Interface

5-71
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port Physical Parameters
How to Configure the Duplex Operation of the Management Interface
• Options, page 5-71
• Configuring the Duplex Operation of the Management Interface: Example, page 5-71
Options
The following options are available:
• duplex — duplex operation of the currently selected management port (0/1 or 0/2):
– full
– half
– auto (default) — auto-negotiation (do not force duplex on the link)
If the speed parameter is configured to auto, changing the duplex parameter has no effect (see ).
Step 1 From the SCE(config if)# prompt, type duplex auto|full|half and press Enter.
Configures the duplex operation of the currently selected management interface.
Configuring the Duplex Operation of the Management Interface: Example
The following example shows how to use this command to configure both management ports to half
duplex mode.
SCE#config
SCE(config)#interface mng 0/1
SCE(config if)#duplex half
SCE(config if)#exit
SCE(config)#interface mng 0/2
SCE(config if)#duplex half
How to Configure the Speed of the Management Interface
• Options, page 5-71
• Configuring the Speed of the Management Interface: Example, page 5-72
Options
The following options are available:
• speed — speed in Mbps of the currently selected management port (0/1 or 0/2):
– 10
– 100
– auto (default) — auto-negotiation (do not force speed on the link)
If the duplex parameter is configured to auto, changing the speed parameter has no effect (see ).
Step 1 From the SCE(config if)# prompt, type speed 10|100|auto and press Enter.
Configures the speed of the currently selected management interface.