EasyManua.ls Logo

Cisco SCE2020-4XGBE-SM - How to Enable the Hardware Packet Drop

Cisco SCE2020-4XGBE-SM
512 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6-28
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 6 Configuring the Line Interface
Counting Dropped Packets
How to Enable the Hardware Packet Drop
Use this command to enable the drop-red-packets-by-hardware mode.
Step 1 From the SCE(config if)# prompt, type accelerate-packet-drops and press Enter.

Table of Contents

Related product manuals