Cisco SCE2020-4XGBE-SM - Monitoring the Management Interface

5-72
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port Physical Parameters
Configuring the Speed of the Management Interface: Example
The following example shows how to use this command to configure both management ports to The
following example shows how to use this command to configure both management ports to half duplex
mode.
SCE#config
SCE(config)#interface mng 0/1
SCE(config if)#speed 100
SCE(config if)#exit
SCE(config)#interface mng 0/2
SCE(config if)#speed 100
Monitoring the Management Interface
Use this command to display the following information for the specified management interface. Speed
and duplex parameters are specific to the selected interface (port), while other parameters apply to both
ports and are displayed by a command to either interface.
• speed
• duplex
• IP address
• active port
Step 1 From the SCE# prompt, type show interface Mng {01 | 0/2} [auto-fail-over|duplex|ip address|speed]
and press Enter.
Displays the specified management interface configuration.
• If no option is specified, all management interface information is displayed.
• The displayed speed and duplex mode are for the management interface specified in the command.