Cisco SCE2020-4XGBE-SM - Introduction; Setup Command Parameters; The Setup Command; Utilities

CHAPTER
4-1
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
4
Utilities
Revised: June 15, 2009, OL-7827-12
Introduction
This module describes the following utilities:
• Setup utility command
• File operation utility commands
• User log utility commands
The Setup Command
• Setup Command Parameters, page 4-1
• Entering the Setup Command, page 4-4
• Defining Lists in the Setup Utility, page 4-4
Setup Command Parameters
The setup utility is an interactive wizard that guides the user through the basic configuration process.
This utility runs automatically upon initial connection to the local terminal. It may also be invoked
explicitly via Telnet or via the local terminal to make changes to the system configuration.
Table 4-1 lists all the command parameters for the setup utility.
Table 4-1 Setup Command Parameters
Parameter Definition
IP address IP address of the SCE platform.
subnet mask Subnet mask of the SCE platform.
default gateway Default gateway.
hostname Character string used to identify the SCE platform. Maximum
length is 20 characters.