Cisco SCE2020-4XGBE-SM - Configuring the Physical Ports; CLI Help Features; Partial Help

2-9
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 2 Command Line Interface
CLI Help Features
Configuring the Physical Ports
The SCE platform contains the following physical port interfaces:
• Management:
The following commands are used to configure the management port:
– ip address
– duplex
– speed
– active-port
– auto-fail-over
• Gigabit Ethernet
The following commands are used to configure the Gigabit Ethernet line ports. These are the
commands for which the range interface mode is relevant; use the range interface command to
configure more than one interface at a time if you are configuring them to identical values.
– auto-negotiate
– bandwidth
– queue
CLI Help Features
CLI provides context sensitive help. Two types of context sensitive help are supported:
• Partial Help, page 2-9
• Argument Help, page 2-10
Partial Help
To obtain a list of commands that begin with a particular character string, enter the abbreviated command
entry immediately followed by a question mark (?). This form of help is called partial help, because it
lists only the keywords or arguments that begin with the abbreviation you entered.
Example:
The following example illustrates how typing c? displays all available arguments that start with the letter
c.
SCE(config)#snmp-server c?
Community contact
SCE(config)#snmp-server c