Cisco SCE2020-4XGBE-SM - How to Remove a Domain Name Server; How to Remove All Domain Name Servers; Adding a Host to the Host Table; Adding Hosts to Removing Them from the Host Table: Examples

5-69
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring Domain Name Server (DNS) Settings
How to Remove a Domain Name Server
Step 1 From the SCE(config)# prompt, type no ip name-server server-address1 [server-address2
[server-address3], and press Enter.
Removes the specified server from the DNS list.
Removing a Domain Name Server: Example
The following example shows how to remove name server (DNS) IP addresses.
SCE(config)#no ip name-server 10.1.1.60 10.1.1.61
How to Remove All Domain Name Servers
Step 1 From the SCE(config)# prompt, type no ip name-server and press Enter.
Removes all configured DNS servers.
Adding a Host to the Host Table
• Options, page 5-69
• Adding Hosts to Removing them from the Host Table: Examples, page 5-69
Options
The following options are available:
• hostname — The name of the host.
• ip-address — The IP address of the host
Step 1 From the SCE(config)# prompt, type ip host hostname ip-address and press Enter.
Adds the specified host to the host table.
Adding Hosts to Removing them from the Host Table: Examples
The following example shows how to add a host to the host table.
SCE(config)#ip host PC85 10.1.1.61
The following example shows how to remove a hostname together with all its IP mappings.
SCE(config)#no ip host PC85