Cisco SCE2020-4XGBE-SM - How to Display Health Check Counters for All VAS Servers; How to Clear the Health Check Counters for a Specified VAS Server; How to Clear the Health Check Counters for All VAS Servers; How to Display Bandwidth Per VAS Server and VAS Direction

12-31
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
Monitoring VAS Traffic Forwarding
How to Display Health Check Counters for All VAS Servers
Step 1 From the SCE> prompt, type show interface linecard 0 VAS-traffic-forwarding VAS server-id all
counters health-check and press Enter.
How to Clear the Health Check Counters for a Specified VAS Server
Step 1 From the SCE> prompt, type clear interface linecard 0 VAS-traffic-forwarding VAS server-id
id-number counters health-check and press Enter.
How to Clear the Health Check Counters for All VAS Servers
Step 1 From the SCE> prompt, type clear interface linecard 0 VAS-traffic-forwarding VAS server-id all
counters health-check and press Enter.
How to Display Bandwidth per VAS Server and VAS Direction
Note that the bandwidth presented in this command is measured at the Transmit queues, therefore the
first table in the example presents the bandwidth of traffic transmitted towards the VAS servers and the
second table presents the bandwidth of traffic transmitted out of the SCE platform after being handled
by the VAS servers.
The counting is based on L2 bytes.
Step 1 From the SCE> prompt, type show interface linecard 0 counters VAS-traffic-bandwidth and press
Enter.
Example
SCE>show interface linecard 0 counters VAS-traffic-bandwidth
Traffic sent to VAS processing TxBW [Kbps] (bytes are counted from Layer 2):
Port 1 Port 2 Port 3 Port 4
-------- -------- -------- --------
VAS server id 0: 0 0 0 0
VAS server id 1: 0 0 0 0
VAS server id 2: 0 0 0 0
VAS server id 3: 0 0 0 0
VAS server id 4: 0 0 0 0
VAS server id 5: 0 0 0 0
VAS server id 6: 0 0 0 0
VAS server id 7: 0 0 0 0