CHAPTER
5-1
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
5
Configuring the Management Interface and
Security
Revised: June 15, 2009, OL-7827-12
Introduction
This module describes how to configure the physical management interfaces (ports) as well as the
various management interface applications, such as SNMP, SSH, and TACACS+. It also explains how to
configure users, passwords, IP configuration, clock and time zone, and domain name settings.
• About Management Interface and Security, page 5-2
• Configuring the Management Ports, page 5-2
• Entering Management Interface Configuration Mode, page 5-3
• Configuring the Management Port Physical Parameters, page 5-3
• Configuring Management Interface Redundancy, page 5-7
• Configuring Management Interface Security, page 5-9
• Configuring the Available Interfaces, page 5-11
• Configuring and Managing the SNMP Interface, page 5-33
• Managing Passwords, page 5-46
• IP Configuration, page 5-52
• Configuring Time Clocks and Time Zone, page 5-58
• Configure SNTP, page 5-64
• Configuring Domain Name Server (DNS) Settings, page 5-67
• Configuring the Management Port Physical Parameters, page 5-70
To Next Page
Loading...
