9-40
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Configuring the SCE Platform/SM Connection
How to Set the Aging Timeout Period for Introduced Subscribers
Options
The following option is available:
• aging-time — the time interval, in minutes, after which an inactive subscriber sill be aged.
Step 1 From the SCE(config if)# prompt, type no subscriber aging introduced timeout aging-time and
press Enter.
How to Display Aging for Anonymous Group Subscribers
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber aging anonymous and press
Enter.
How to Display Aging for Introduced Subscribers
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber aging introduced and press
Enter.
Configuring the SCE Platform/SM Connection
• Options, page 9-41
• Configuring the Behavior of the SCE Platform in Case of Failure of the SM, page 9-41
• Configuring the SM-SCE Platform Connection Timeout, page 9-42
The user can configure the behavior of the SCE platform in case of failure of the Subscriber Manager
(SM):
• If SM functionality is critical to the operation of the system — configure the desired behavior of the
SCE platform if any loss of connection with the SM (may be due either to failure of the SM or failure
of the connection itself).
• If SM functionality is not critical to the operation of the system — no action needs to be configured.
In this case you can specify that the system operational-status of the SCE platform should be
'warning' when the link is down.
To Next Page
Loading...
