A-2
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Appendix A Monitoring SCE Platform Utilization
SCE Platform Utilization Indicators
SCE Platform Utilization Indicators
• CPU Utilization, page A-2
• Flows Capacity, page A-2
• Subscribers Capacity, page A-2
The SCE platform exposes several indicators to allow the network operators to easily monitor whether
it is working within its performance and capacity specifications:
• CPU Utilization
• Flows capacity
• Subscribers capacity
CPU Utilization
• SNMP
tpCpuUtilization, available for each Traffic Processor (TpInfoEntry ) in the PCubeSeMib.mib.
• CLI command
show snmp MIB pcube-SE-MIB traffic-processor | include tpCpuUtilization
It is advisable to consider sizing of the solution when the CPU utilization exceeds 75% regularly at peak
hours.
Flows Capacity
• SNMP
tpFlowsCapacityUtilization, available for each Traffic Processor (TpInfoEntry ) in the
PCubeSeMib.mib
• CLI command
show snmp MIB pcube-SE-MIB traffic-processor | include tpFlowsCapacityUtilization
It is advisable to consider sizing of the solution when the flows capacity utilization exceeds 90%
regularly at peak hours.
Subscribers Capacity
• SNMP
subscribersInfoEntry, available in the PCubeSeMib.mib
• CLI command
show snmp MIB pcube-SE-MIB subscriber
The SCE 2000 platform supports up to 80K subscribers, while the SCE 1000 supports up to 40K
subscribers. You should make sure that the number of Introduced Subscribers plus the number of
Anonymous Subscribers stays below this figure.
It is advisable that when subscribers utilization exceeds 90%, special attention should be given and
sizing should be reconsidered.
To Next Page
Loading...
