Cisco SCE2020-4XGBE-SM - How to Configure Pseudo IP Addresses for the Health Check Packets

12-23
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
Configuring VAS Traffic Forwarding
Options
The following options are available:
• number — The ID number of the VAS server for which to enable or disable the health check
• Enable/disable — Enable or disable VAS server health check
– Default — Enable
• UDP ports — Specify the UDP ports to be used for the health check:
– source portnumber — health check source port number
– destination portnumber — health check destination port number
– Default — <63140,63141>used for server #0 through <63154,63155>used for server #7.
How to Enable VAS Server Health Check
Step 1 From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number health-check
and press Enter.
How to Disable VAS Server Health Check
Step 1 From the SCE(config if)# prompt, type no VAS-traffic-forwarding VAS server-id number
health-check and press Enter.
How to Define the UDP Ports to be Used for Health Check
Step 1 From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number health-check
UDP ports source portnumber destination portnumber and press Enter.
How to Remove the UDP Ports Configuration
Step 1 From the SCE(config if)# prompt, type no VAS-traffic-forwarding VAS server-id number
health-check UDP ports and press Enter.
You can also use the default form of the command to remove the UDP port configuration.
VAS-traffic-forwarding VAS server-id number health-check UDP ports
How to Configure Pseudo IP Addresses for the Health Check Packets
• About Pseudo IP Addresses, page 12-24
• Options, page 12-24
• How to Define the pseudo IP Address, page 12-24
• How to Delete the pseudo IP Address, page 12-24