Cisco SCE2020-4XGBE-SM - How to Export Tirs to a Csv File; How to Import Tirs from a Csv File; How to Monitor Tirs

9-35
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Subscriber Traffic Processor IP Ranges
How to Import TIRs from a csv File
Step 1 From the SCE(config if)# prompt, type subscriber TP-IP-range import csv-file file-name
[remove-subscriber-mappings] and press Enter.
Imports the TIR definitions from the specified csv file.
If the remove-subscriber-mappings keyword is specified, if subscriber mappings exist for any specified
IP range, they will be removed and the command will execute successfully. Otherwise, if subscriber
mappings exist for any IP range, those IP ranges will not be updated.
How to Export TIRs to a csv File
Step 1 From the SCE(config if)# prompt, type subscriber TP-IP-range export csv-file file-name and press
Enter.
Exports current TIR definitions to the specified csv file.
The remove-subscriber-mappings option is not applicable to this command.
How to Monitor TIRs
• How to Display Traffic Processor Mappings State, page 9-36
• How to Display Configuration of a Specified TIR, page 9-36
• How to Display Configuration of All TIRs, page 9-36
• How to Display Mappings Related to a Specified TIR, page 9-36
• How to Display the Number of Subscribers with Mappings Related to a Specified TIR, page 9-36
• How to Display Complete Subscriber Information, page 9-36
• How to Display All Subscribers Mapped to a Specified IP Range, page 9-37
• How to Display the Number of Subscribers Mapped to a Specified IP Range, page 9-37
Use these commands to monitor TIRs and subscriber mappings. You can view the following:
• Traffic processor mappings state, including the partitioning between subscriber and TIR mappings,
and the utilization of each.
• Configuration of a specified TIR Configuration of all TIRs
• All subscriber mappings related to a specified TIR
• Number of subscribers with mappings related to a specified TIR
• Information for a specified subscriber, including assigned TIR, where applicable
• All subscriber mappings in a specified IP range
• Number of subscribers with mappings in a specified IP range