Cisco SCE2020-4XGBE-SM - About VPN-Based Subscribers; How to Remove Subscribers by Device; How to Remove Subscribers from a Specified SCMP Peer Device; How to Remove Subscribers from the SM

9-13
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Removing Subscribers and Templates
About VPN-based Subscribers
All VPN-based subscribers must be cleared to change the tunneling mode. If there are VPN-based
subscribers that the SM cannot remove for some reason (for example, if there is no communication
between the SM and the SCE platform), use this command.
This command allows you to switch out of MPLS/VPN mode without reload when the SM is down.
Note Use this command ONLY when the SCE platform is disconnected from the SM.
Step 1 From the SCE(config if)# prompt, type no subscriber all with-vpn-mappings and press Enter.
Clears all VPN-based subscribers.
How to Remove Subscribers by Device
You can remove all subscribers managed by a specified device. The device can be either of the following:
• The SM
• A specified SCMP peer device
How to Remove Subscribers from the SM
Step 1 From the SCE(config if)# prompt, type no subscriber sm all and press Enter.
Clears all subscribers from the SM.
How to Remove Subscribers from a Specified SCMP Peer Device
Options
The following option is available:
• peer-device-name — the name of the SCMP peer device from which to clear the subscribers.
Step 1 From the SCE(config if)# prompt, type no subscriber scmp name peer-device-name all and press
Enter.
Clears all subscribers from the specified SCMP peer device.