Cisco SCE2020-4XGBE-SM - Navigating between Authorization Levels and Command Modes

2-7
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 2 Command Line Interface
Authorization and Command Levels (Hierarchy)
Command hierarchy levels are indicated as shown in Table 2-4.
Example:
The prompt SCE1(config if)# indicates:
• The name of the SCE platform is SCE1
• The current CLI mode is Interface configuration mode
• The user has Admin authorization level
Navigating Between Authorization Levels and Command Modes
The authorization levels and command modes function together in one hierarchy. The User and Viewer
authorization levels have only a single command mode. When you enter either the Admin or Root
authorization level (which function in parallel), you enter the Privileged Exec command mode. From
this command mode you can access the other command modes.
• User Exec authorization level
• Viewer authorization level
• Privileged Exec command mode (you are now in either Admin or Root authorization level)
• Global Configuration command mode
From this command mode, the following Interface Command Modes can be accessed:
– Management Interface Configuration
– Linecard Interface Configuration
– GigabitEthernet Interface Configuration (GBE traffic interfaces)
– Interface Range Configuration (range of traffic interfaces)
– Line Configuration
Table 2-4 Prompt Indications: Command Mode Levels
This command hierarchy... Is indicated as...
User Exec SCE>
Privileged Exec sce#
Global Configuration SCE (config)#
Interface Configuration SCE (config if)#
Interface Range Configuration SCE (config if range)#
Line Configuration SCE (config-line)#