Cisco SCE2020-4XGBE-SM - How to Display Complete Subscriber Information; How to Display Configuration of a Specified TIR; How to Display Configuration of All Tirs; How to Display Mappings Related to a Specified TIR

9-36
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Subscriber Traffic Processor IP Ranges
How to Display Traffic Processor Mappings State
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber TP-mappings statistics and
press Enter.
How to Display Configuration of a Specified TIR
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber TP-IP-range name tir-name
and press Enter.
How to Display Configuration of All TIRs
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber TP-IP-range all and press
Enter.
How to Display Mappings Related to a Specified TIR
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping included-in
TP-IP-range name
tir-name and press Enter.
How to Display the Number of Subscribers with Mappings Related to a Specified TIR
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount mapping included-in
TP-IP-range name
tir-name and press Enter.
How to Display Complete Subscriber Information
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber name name and press Enter.
Displays complete subscriber information, including which TIR the subscriber belongs to (if applicable).