Cisco SCE2020-4XGBE-SM - How to Display the Configuration All Currently Defined SCMP Peer Devices; How to Display the Configuration for a Specified SCMP Peer Device; How to Display the General SCMP Configuration; How to Display the Statistics for All SCMP Peer Devices

14-17
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 14 Managing the SCMP
Monitoring the SCMP Environment
How to display the general SCMP configuration
Step 1 From the SCE> prompt, type show scmp and press Enter.
Example
SCE>show scmp
SCMP enabled: yes
Keep-alive interval: 5 seconds
Loss of synchronization timeout: 90 seconds from disconnection
Reconnection interval: 30 seconds
Force subscriber on a single SCE: no
Peer sends subscriber data on session start
Subscriber Id structure: GUID
How to display the configuration all currently defined SCMP peer devices
Step 1 From the SCE> prompt, type show scmp all and press Enter.
How to display the configuration for a specified SCMP peer device
Step 1 From the SCE> prompt, type show scmp name device-name and press Enter.
Example
SCE>show scmp name isg
SCMP Connection 'isg' status:
10.56.208.91 auth-port 1812 acct-port 1813
Connection state: Connected
Peer protocol-version: 1.0
Keep-alive interval: 5 seconds
Force single SCE: No
Send session start: Yes
Time connected: 9 seconds
How to display the statistics for all SCMP peer devices
Step 1 From the SCE> prompt, type show scmp all counters and press Enter.