9-22
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Monitoring Subscribers
How to display subscribers that are mapped to a specified IP address, or range of IP addresses
Options
The following options are available:
• ip-range — IP address (x.x.x.x) or range of IP addresses (x.x.x.x/y) to match
• vpn-name (optional) — The name of the VPN in which to search for the IP address
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping IP ip-range [VPN
vpn-name ]
and press Enter.
How to display subscribers that are mapped to IP addresses that are included in a given IP address or IP range
Options
The following options are available:
• ip-range — IP address (x.x.x.x) or range of IP addresses (x.x.x.x/y) to match
• vpn-name (optional) — The name of the VPN in which to search for the IP address
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping included-in IP
ip-range [VPN vpn-name ] and press Enter.
How to display subscribers that are mapped to a specified VLAN ID
Options
The following options are available:
• VLAN-id — VLAN ID to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping VLAN-id VLAN-id
and press Enter.
How to display subscribers that are mapped to a specified MPLS/VPN
Options
The following options are available:
• pe-id — loopback IP address of the relevant PE router
• bgp-label — label of the relevant BGP LEG
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping MPLS-VPN PE-ID pe-id
bgp-label BGP-label and press Enter.
To Next Page
Loading...
