5-21
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
Options
The following options are available:
• name — name of the user whose privilege level is set
• level — the privilege level permitted to the specified user. These levels correspond to the CLI
authorization levels, which are entered via the enable command:
–
0 — User
–
10 — Admin
–
15 (default) — Root
Step 1 From the SCE(config)# prompt, type username name privilege level and press Enter.
How to Add a New User with Privilege Level and Password
Use these commands to define a new user, including password and privilege level, in a single command.
Note In the config files (running config and startup config ), this command will appear as two separate
commands.
• Options, page 5-21
• How to Add a User with a Privilege Level and a Clear Text Password, page 5-22
• How to Add a User with a Privilege Level and an MD5 Encrypted Password Entered in Clear Text,
page 5-22
• How to Add a User with a Privilege Level and an MD5 Encrypted Password Entered as an MD5
Encrypted String, page 5-22
Options
The following options are available:
• name — name of the user whose privilege level is set
• level — the privilege level permitted to the specified user. These levels correspond to the CLI
authorization levels, which are entered via the enable command:
–
0 — User
–
10 — Admin
–
15 (default) — Root
• password — a clear text password. May be saved in the local list in either of two formats:
–
as clear text I
–
n MD5 encrypted form if the secret keyword is used
• encrypted-secret — an MD5 encryption string password
To Next Page
Loading...
