5-38
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring and Managing the SNMP Interface
These are the details of specific objects in this MIB:
Information About ENTITY-MIB
• ENTITY-MIB, page 5-38
• entityPhysical group, page 5-39
• entityGeneral group, page 5-39
ENTITY-MIB
The Entity-MIB contains five groups of MIB objects:
• entityPhysical group
• entityLogical group
• entityMapping group
• entityGeneral group
• entityNotifications group
The SCOS implements only the physical and the general groups of the Entity-MIB, since the other
groups are not relevant to the SCE platform.
ifindex The numbering of the interfaces is such that the port(s) come first.
ifPhysAddress For Management interfaces, this is the MAC address.
For traffic interfaces, this is an all zeros address.
IfAdminStatus Write operation to this object is not supported. This is OK according to
Ethernet MIB RFC2665 section 3.2.7
IfOutQLen Always returns 0.
Under ifXTable: ifname The same as ifDescr.
ifpromiscuousmode Management interface – “false”.
Traffic interfaces – “true”.
ifRcvAddressTable Not implemented
iftesttable Was deprecated by RFC-2233, and is therefore not implemented
To Next Page
Loading...
