xxxiv
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
About this Guide
Introduction
Organization
This guide contains the following sections:
Table 2 Document Organization
Section Title Description
1 Cisco Service Control Overview,
page 1-1
Overview of SCE platform management.
2 Command Line Interface, page 2-1 Detailed explanation of how to use the Cisco SCE
Command-line Interface.
3 Operations, page 3-1 Explanation of how to manage configurations,
install applications and upgrade the system
software.
4 Utilities, page 4-1 Explanation of the setup wizard and the user log,
as well as of file operations.
5 Configuring the Management
Interface and Security, page 5-1
Explanation of how to configure the various
management options: Telnet, SSH, and SNMP.
Also how to configure the system time, Domain
Name Settings, management IP address, and
passwords.
6 Configuring the Line Interface,
page 6-1
Explanation of how to configure tunneling, TOS
marking, and traffic rules.
7 Configuring the Connection, page 7-1 Explanation of how to configure the connection
mode, link mode, and failure behaviors
8 Raw Data Formatting: The RDR
Formatter and NetFlow Exporting,
page 8-1
Explanation of how to configure the connection
mode, link mode, and failure behaviors.
9 Managing Subscribers, page 9-1 Explanation of how to import and export
subscriber information and how to monitor
subscribers.
10 Redundancy and Fail-Over, page 10-1 Explanation of how to configure and manage a
redundant system.
This chapter applies only to the SCE 2000
platform
11 Identifying and Preventing
Distributed-Denial-Of-Service
Attacks, page 11-1
Explanation of how to configure attack filtering
12 Value Added Services (VAS) Traffic
Forwarding, page 12-1
Explanation of Value Added Services (VAS) and
how to configure VAS traffic forwarding
13 MPLS/VPN Support, page 13-1 Explanation of MPLS/VPN support, and how to
configure and monitor MPLS/VPN subscribers
and support
To Next Page
Loading...
