Cisco SCE2020-4XGBE-SM - Page 51

2-5
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 2 Command Line Interface
Authorization and Command Levels (Hierarchy)
Figure 2-1 CLI Command Modes
The following commands are used to enter the different configure interface modes and the Line
Configuration Mode:
• E1 interface Linecard 0
• E2 interface Mng 0/1 or 0/2 (management port, all platforms)
• E3:
– SCE 1000: interface GigabitEthernet 0/1 or 0/2
– SCE 2000: interface TenGigabitEthernet 0/1, 0/2, 0/3, or 0/4
• E4:
– SCE 1000: interface range GigabitEthernet 0/1-2
– SCE 2000: interface range TenGigabitEthernet 0/<port-range (any range between 1 and
4)>
• E5 line vty 0
Note Although the system supports up to five concurrent Telnet connections, you cannot configure them
separately. This means that any number you enter in the line vty command (0, 1, 2, 3 or 4 ) will act as a
0 and configure all five connections together.
ExitE5ExitExitE1 ExitE2 ExitE3 E4
Interface
Range
Configuration
Mode
Line
Configuration
Mode
Interface
Configuration
Mode
(Traffic)
Management
Interface
Configuration
Mode
Interface Configuration Mode
Line Card
Interface
Configuration
Mode
Privileged Exec Mode
Global Configuration Mode
ExitConfigure
User Exec Mode
DisableEnable
210640