Contents
iv
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Generating a File for Technical Support 4-11
Generating a File for Technical Support: Example 4-11
Flow Capture 4-12
Limitations 4-12
The Flow Capture Process 4-12
Configuring a Flow Capture Traffic Rule 4-13
Configuring the Flow Capture Settings 4-13
Performing the Flow Capture 4-14
Monitoring the Flow Capture 4-15
CHAPTER
5 Configuring the Management Interface and Security 5-1
Introduction 5-1
About Management Interface and Security 5-2
Configuring the Management Ports 5-2
Entering Management Interface Configuration Mode 5-3
Configuring the Management Port Physical Parameters 5-3
Setting the IP Address and Subnet Mask of the Management Interface 5-4
Options 5-4
Setting the IP Address and Subnet Mask of the Management Interface: Example 5-4
Configuring the Management Interface Speed and Duplex Parameters 5-5
Interface State Relationship to Speed and Duplex 5-5
How to Configure the Speed of the Management Interface 5-5
How to Configure the Duplex Operation of the Management Interface 5-6
Specifying the Active Management Port 5-6
Options 5-7
Specifying the Active Management Port: Example 5-7
Configuring Management Interface Redundancy 5-7
About Management Port Redundancy 5-7
How to Configure the Management Ports for Redundancy 5-8
Configuring the Fail-Over Mode 5-8
Options 5-8
How to Enable Automatic Fail-Over Mode 5-8
How to Disable Automatic Fail-Over Mode 5-9
Configuring Management Interface Security 5-9
Configuring the IP Fragment Filter 5-9
Options 5-9
How to Enable the IP Fragment Filter 5-10
How to Disable the IP Fragment Filter 5-10
Configuring the Permitted and Not-permitted IP Address Monitor 5-10
To Next Page
Loading...
