6. Check Port-Based VLAN settings.
Switch Management>VLAN Configuration>Port Based VLAN>Configure VLAN
NOTE: By default, all ports are member ports of the Default_VLAN. Before removing the
Deafult_VLAN from the VLAN table, make sure you have correct management VLAN and PVID
configurations, otherwise, incorrect configurations may disconnect your management PC to the
Managed Switch immediately when you enter the command.
Treatments of packets:
1. A untagged packet arrives at Port 1
Untagged packets received on the Managed Switch will be forwarded out untagged. Therefore, in
this example, the Managed Switch will look at the Port-Based forwarding table for Port 1 and
forward untagged packets to member port 21, 23, and 26.
2. A untagged packet arrives at Port 2
Untagged packets received on the Managed Switch will be forwarded out untagged. Therefore, in
this example, the Managed Switch will look at the Port-Based forwarding table for Port 2 and
forward untagged packets to member port 22, 23, and 26.
3. A tagged packet with any permissible VID arrives at Port 1
Tagged packets received on the Managed Switch will be forwarded out tagged. Therefore, in this
example, the Managed Switch will look at the Port-Based forwarding table for Port 1 and forward
tagged packets to member port 21, 23, and 26.
4. A tagged packet with any permissible VID arrives at Port 2
Tagged packets received on the Managed Switch will be forwarded out tagged. Therefore, in this
example, the Managed Switch will look at the Port-Based forwarding table for Port 2 and forward
tagged packets to member port 22, 23, and 26.
To Next Page
Loading...
Need help?
General
