CTS FOS-3126-PLUS SERIES - Page 53

53
Switch(config)# lldp
interval [1-180]
[1-180]
Specify the time interval for updated LLDP packets
to be sent. The allowable interval value is between
1 and 180 seconds.
Switch(config)# lldp
packets [1-16]
[1-16]
Specify the amount of packets that are sent in
each discovery. The allowable packet value is
between 1 and 16 seconds.
Switch(config)# lldp tlv-
select capability
Enable Capability attribute to be sent.
Switch(config)# lldp tlv-
select management-
address
Enable Management Address attribute to be sent.
Switch(config)# lldp tlv-
select port-description
Enable Port Description attribute to be sent.
Switch(config)# lldp tlv-
select system-
description
Enable System Description attribute to be sent.
Switch(config)# lldp tlv-
select system-name
Enable System Name attribute to be sent.
No command
Switch(config)# no lldp hold-time
Reset the hold-time value back to the default
setting.
Switch(config)# no lldp initiated-delay
Reset the initiated-delay value back to the default
setting.
Switch(config)# no lldp interval
Reset the interval value back to the default setting.
Switch(config)# no lldp packets
Reset the packets-to-be-sent value back to the
default setting.
Switch(config)# no lldp tlv-select
capability
Disable Capability attribute to be sent.
Switch(config)# no lldp tlv-select
management-address
Disable Management Address attribute to be sent.
Switch(config)# no lldp tlv-select port-
description
Disable Port Description attribute to be sent.
Switch(config)# no lldp tlv-select
system-description
Disable System Description attribute to be sent.
Switch(config)# no lldp tlv-select
system-name
Disable System Name attribute to be sent.
Show command
Switch(config)# show lldp
Show or verify LLDP settings.
Switch(config)# show lldp interface
Show or verify each interface‟s LLDP port state.
Switch(config)# show lldp interface
[port_list]
Show or verify the selected interfaces‟ LLDP port
state.
Switch(config)# show lldp status
Show current LLDP status.
LLDP command example
Description
Switch(config)# lldp hold-time 60
Set the hold-time value to 60 seconds.
Switch(config)# lldp initiated-delay 60
Set the initiated-delay value to 60 seconds
Switch(config)# lldp interval 10
Set the updated LLDP packets to be sent in very
10 seconds.
Switch(config)# lldp packets 2
Set the number of packets to be sent in each
discovery to 2.
Switch(config)# lldp tlv-select
capability
Enable Capability attribute to be sent.
Switch(config)# lldp tlv-select
management-address
Enable Management Address attribute to be sent.