CTS FOS-3126-PLUS SERIES User Manual

61
Switch(config-if-PORT-PORT)#
qos queuing-mode [weight]
[weight]
Specify egress mode as weight
queuing mode. The default queuing-
mode is strict.
“weight”: Weighted Round-Robin
shares bandwidth at the egress
ports by using scheduling weights 1,
2, 4, 8 for queues 1 through 4
respectively.
“strict”: This indicates that services
to the egress queues are offered in
the sequential order and all traffic
with higher priority queues is
transmitted first before lower priority
queues are serviced.
Switch(config-if-PORT-PORT)#
qos qcl [1-26]
[1-26]
Apply the selected ports to the
specified QCL rule.
Switch(config-if-PORT-PORT)#
qos rate-limit ingress [0 | 500-
1000000] kbps
[0 | 500-
1000000]
kbps
Specify ingress rate limit value.
Switch(config-if-PORT-PORT)#
qos rate-limit egress [0 | 500-
1000000] kbps
[0 | 500-
1000000]
kbps
Specify egress rate limit value.
Switch(config-if-PORT-PORT)#
qos remarking dscp
Enable DSCP bit remarking on the
selected interfaces.
Switch(config-if-PORT-PORT)#
qos remarking 802.1p
Enable 802.1p remarking on the
selected interfaces.
Switch(config-if-PORT-PORT)#
qos remarking user-priority [0-7]
[0-7]
Specify the default priority bit to the
selected interfaces.
Switch(config-if-PORT-PORT)#
qos queue-weighted [1:2:4:8]
[1:2:4:8]
Specify the queue weight of the
selected interfaces.
No command
Switch(config-if-PORT-PORT)# no qos default-
class
Set QoS default class setting back
to default.
Switch(config-if-PORT-PORT)# no qos queuing-
mode
Set queuing mode setting back to
the factory default.
Switch(config-if-PORT-PORT)# no qos qcl
Remove the QCL rule from the
selected interfaces.
Switch(config-if-PORT-PORT)# no qos rate-limit
ingress
Delete QoS ingress rate limit
setting.
Switch(config-if-PORT-PORT)# no qos rate-limit
egress
Delete QoS egress rate limit setting.
Switch(config-if-PORT-PORT)# no qos remarking
dscp
Remove DSCP remarking from the
selected ports.
Switch(config-if-PORT-PORT)# no qos remarking
802.1p
Remove 802.1p remarking from the
selected ports.
Switch(config-if-PORT-PORT)# no qos user-
priority
Set the user priority value setting
back to the factory default.
Switch(config-if-PORT-PORT)# no qos queue-
weighted
Set the weight setting back to the
factory default.
Show command
Switch(config)# show qos
Show or verify QoS configurations.

CTS FOS-3126-PLUS SERIES Specifications

General

Brand	CTS
Model	FOS-3126-PLUS SERIES
Category	Switch
Language	English