CTS FOS-3126-PLUS SERIES - Page 80

80
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode access
Set the selected ports that belong to
the specified VLAN to access mode
(untagged).
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode dot1q-
tunnel
Enable Q-in-Q function in the selected
interfaces.
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode trunk
Set the selected ports to trunk mode
(tagged).
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode trunk native
Enable native VLAN for untagged
traffic.
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan trunk-vlan [1-
4094]
[1-4094]
Specify a VID to trunk VLAN.
Switch(config-if-PORT-PORT)#
vlan port-based [name]
[name]
Set the selected ports to a specified
port-based VLAN.
No command
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan access-vlan
Set the selected ports‟ PVID to the
default setting.
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan mode
Remove VLAN dot1q mode.
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan mode trunk
native
Disable native VLAN for untagged
traffic.
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan trunk-vlan [1-
4094]
[1-4094]
Remove the selected ports‟ from the
specified trunk VLAN.
Switch(config-if-PORT-PORT)#
no vlan port-based [name]
[name]
Delete the selected ports from the
specified port-based VLAN.
VLAN & interface command example
Switch(config)# interface 1-3
Enter port 1 to port 3‟s interface mode.
Switch(config-if-1-3)# vlan dot1q-vlan access-
vlan 10
Set port 1 to port 3‟s VLAN ID (PVID)
to 10.
Switch(config-if-1-3)# vlan dot1q-vlan mode
access
Set the selected ports to access mode
(untagged).
Switch(config-if-1-3)# vlan dot1q-vlan mode
dot1q-tunnel
Enable Q-in-Q function in the selected
interfaces.
Switch(config-if-1-3)# vlan dot1q-vlan mode
trunk native
Enable native VLAN for untagged
traffic.
Switch(config-if-1-3)# vlan port-based
mktpbvlan
Set the selected ports to the specified
port-based VLAN “mktpbvlan”.