CTS FOS-3128 Series - Page 125

125
Switch(config-if-PORT-
PORT)# no spanning-tree p2p
Reset the selected
interfaces back to point to
point ports (forced_ true).
16. Set up port speed.
Command
Parameter
Description
Switch(config-if-PORT-PORT)#
speed [1000|100|10]
[1000|100|10]
Configure the port speed as 1000Mbps,
100Mbps or 10Mbps.
Note1: Speed can only be configured
when auto-negotiation is disabled.
Note2: Fiber ports cannot be
configured as 10Mbps.
No command
Switch(config-if-PORT-PORT)#
no speed
Reset the port speed setting back to the
default.
17. Set up VLAN parameters per port.
Command
Parameter
Description
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan access-vlan [1-
4094]
[1-4094]
Specify the selected ports’ Access-VLAN
ID (PVID).
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan trunk-vlan [1-
4094]
[1-4094]
Specify the selected ports’ Access-VLAN
ID (PVID).
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode access
Set the selected ports to the access mode
(untagged).
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode trunk
Set the selected ports to the trunk mode
(tagged).
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode trunk
native
Enable native VLAN for untagged traffic
on the selected port. (Tagged and
untagged)
Note : When you assign a default
Access-VLAN to the trunk-native port,
all untagged traffic travels on the
default Access-VLAN for the trunk-
native port, and all untagged traffic is
assumed to belong to this Access-
VLAN.
Switch(config-if-PORT-PORT)#
vlan port-based [name]
[name]
Set the selected ports to a specified port-
based VLAN.
Note :
Need to create a port-based VLAN
group under the VLAN global
configuration mode before joining it.