CTS FOS-3128 Series - Page 126

126
No command
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan access-vlan
Reset the selected ports’ PVID back to
the default setting.
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan trunk-vlan [1-
4094]
[1-4094]
Remove the specified trunk VLAN ID from
the selected ports.
Switch(config-if-PORT-PORT)#
no vlan dot1q-vlan mode
Reset the selected ports’ 802.1q VLAN
mode back to the default setting (Access
Mode).
Switch(config-if-PORT-PORT)#
no vlan port-based [name]
[name]
Remove the selected ports from the
specified port-based VLAN.
18. Set up MAC Limit.
Command
Parameter
Description
Switch(config-if-PORT-
PORT)# security mac-limit
Enable MAC Limit function of the selected
port(s).
Switch(config-if-PORT-
PORT)# security mac-limit
maximum [0-1024]
[0-1024]
Specify the number of MAC address that
can be learned. “0” indicates there is no
limit on specified ports. The valid range of
number that can be configured is 0~1024.
No Command
Switch(config-if-PORT-
PORT)# no security mac-limit
Disable MAC Limit function of the selected
port(s).
Switch(config-if-PORT-
PORT)# no security mac-limit
maximum
Reset the MAC Limit back to the default
“0”. “0” indicates there is no limit on
specified ports.