D-Link DGS-3000 series - Page 103

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
99
DGS-3000-26TC:admin#show flow_meter
Command: show flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:1 Mode : trTCM / ColorBlind
CIR(Kbps):1000 CBS(Kbyte):2000 PIR(Kbps):2000 PBS(Kbyte):2000
Action:
Conform : Permit Counter: Enabled
Exceed : Permit Replace DSCP: 60 Counter: Enabled
Violate : Drop Counter: Disabled
------------------------------------------------------------------------------
Total Entries: 1
DGS-3000-26TC:admin#
6-7 config time_range
Description
This command is used to define a specific range of time to activate a function on the Switch by
specifying which time range in a day and which days in a week are covered in the time range. Note
that the specified time range is based on the SNTP time or the configured time. If this time is not
available, the time range will not be met.
Format
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> | delete]
Parameters
time_range - Specifies the name of the time range settings.
<range_name 32> - Enter the time range name used here. This name can be up to 32
characters long.
hours - Specifies the time of a day.
start_time - Specifies the starting time of a day.
<time hh:mm:ss> - Enter the starting time here. (24-hr time). For example, 19:00 means
7PM. 19 is also acceptable. The time specified in the start_time parameter must be
smaller than the time specified in the end_time parameter.
end_time - Specifies the ending time of a day. (24-hr time)
<time hh:mm:ss> - Enter the ending time here. (24-hr time). For example, 19:00 means
7PM. 19 is also acceptable. The time specified in the start_time parameter must be
smaller than the time specified in the end_time parameter.
weekdays - Specifies the list of days contained in the time range. Use a dash to define a period
of days. Use a comma to separate specific days.
<daylist> - Enter the weekdays that will be included in this configuration here. For example,
mon-fri (Monday to Friday). sun, mon, fri (Sunday, Monday and Friday)
delete - Deletes a time range profile. When a time_range profile has been associated with ACL
entries, deleting the time_range profile will fail.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.