DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
320
34-22 clear address_binding nd_snoop binding_entry ports
Description
This command is used to clear the ND snooping entries on specified ports.
Format
clear addre
ss_binding nd_snoop binding_entry por
ts [<portlist> | al
l]
Parameters
<portlist> - Enter the list of ports that you would like to clear the ND snoop learned entry.
all - Specifies to clear all ND snooping learned entries.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear ND snooping entry on ports 1-3:
DGS-3000-26TC:admin#clear address_binding nd_snoop binding_entry ports 1-3
Command: clear address_binding nd_snoop binding_entry ports 1-3
Success.
34-23 enable address_binding trap_log
Description
This command is used to send traps and logs when the IMPB module detects an illegal IP and
MAC address.
Format
enable address_binding trap_log
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the IMPB traps and logs:
To Next Page
Loading...
