D-Link DGS-3000 series - Page 325

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
321
DGS-3000-26TC:admin#enable address_binding trap_log
Command: enable address_binding trap_log
Success.
DGS-3000-26TC:admin#
34-24 disable address_binding trap_log
Description
This command is used to disable the IMPB traps and logs.
Format
disable address_binding trap_log
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable IMPB traps and logs:
DGS-3000-26TC:admin#disable address_binding trap_log
Command: disable address_binding trap_log
Success.
DGS-3000-26TC:admin#
34-25 config address_binding recover_learning
Description
This command is used to recover IMPB checking.
Format
config address_binding recover_learning ports [<portlist> | all]
Parameters
ports - Specifies the list of ports that need to recover the IMPB check.
<portlist> - Enter the list of port used here.
all - Specifies that all the ports will be used.