D-Link DGS-3000 series - Page 345

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
341
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable JWAC quarantine server monitoring:
DGS-3000-26TC:admin#disable jwac quarantine_server_monitor
Command: disable jwac quarantine_server_monitor
Success.
DGS-3000-26TC:admin#
37-14 config jwac quarantine_server_error_timeout
Description
This command is used to set the quarantine server error timeout. When the quarantine server
monitor is enabled, the JWAC switch will periodically check if the quarantine works okay. If the
Switch does not receive any response from quarantine server during the configured error timeout,
the Switch then regards it as not working properly.
Format
config jwac quarantine_server_error_timeout <sec 5-300>
Parameters
<sec 5-300> - Specifies the error timeout interval.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the quarantine server error timeout:
DGS-3000-26TC:admin#config jwac quarantine_server_error_timeout 60
Command: config jwac quarantine_server_error_timeout 60
Success.
DGS-3000-26TC:admin#