DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
345
Example
To configure the JWAC port state:
DGS-3000-26TC:admin#config jwac ports 1-9 state enable
Command: config jwac ports 1-9 state enable
Success.
37-19 show jwac ports
Description
This command is used to display the port configuration of JWAC.
Format
show jwac ports
{
<portli
s
t>}
Parameters
<portlist> - (Optional) Specifies a port range to show the configuration of JWAC.
Restrictions
None.
Example
To display JWAC ports 1 to 4:
DGS-3000-26TC:admin#show jwac ports 1-4
Command: show jwac ports 1-4
Port State Aging Time Idle Time Block Time Auth Mode Max
(min) (min) (sec) Hosts
----- -------- ---------- --------- ---------- ---------- -----
1 Enabled 1440 Infinite 60 Host-Based 50
2 Enabled 1440 Infinite 60 Host-Based 50
3 Enabled 1440 Infinite 60 Host-Based 50
4 Enabled 1440 Infinite 60 Host-Based 50
37-20 config jwac radius_protocol
Description
This command is used to specify the RADIUS protocol used by JWAC to complete RADIUS
authentication.
To Next Page
Loading...
