D-Link DGS-3000 series - Page 350

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
346
JWAC shares other RADIUS configurations with 802.1X. When using this command to set the
RADIUS protocol, make sure the RADIUS server added by the config radius command supports
the protocol.
Format
config jwac radius_protocol [local | eap_md5 | pap | chap | ms_chap | ms_chapv2]
Parameters
local - Specifies the JWAC switch uses the local user DB to complete the authentication.
eap_md5 - Specifies the JWAC switch uses EAP MD5 to communicate with the RADIUS server.
pap - Specifies the JWAC switch uses PAP to communicate with the RADIUS server.
chap - Specifies the JWAC switch uses CHAP to communicate with the RADIUS server.
ms_chap - Specifies the JWAC switch uses MS-CHAP to communicate with the RADIUS server.
ms_chapv2 - Specifies the JWAC switch uses MS-CHAPv2 to communicate with the RADIUS
server.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the RADIUS protocol used by JWAC:
DGS-3000-26TC:admin#config jwac radius_protocol ms_chapv2
Command: config jwac radius_protocol ms_chapv2
Success.
DGS-3000-26TC:admin#
37-21 create jwac user
Description
This command is used to create JWAC users in the local database. When “local” is chosen while
configuring the JWAC RADIUS protocol, the local database will be used.
Format
create jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Specifies the user name to be created.
vlan - (Optional) Specifies the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Specifies the target VLAN ID for the authenticated host which uses this
user account to pass authentication. The VLAN ID value must be between 1 and 4094.