D-Link DGS-3000 series - Page 351

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
347
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a JWAC user in the local database:
DGS-3000-26TC:admin#create jwac user 112233
Command: create jwac user 112233
Enter a case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-3000-26TC:admin#
37-22 config jwac user
Description
This command is used to configure a JWAC user.
Format
config jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Specifies the user name to be configured.
vlan - (Optional) Specifies the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Specifies the target VLAN ID for the authenticated host which uses this
user account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a JWAC user:
DGS-3000-26TC:admin#config jwac user 112233
Command: config jwac user 112233
Enter a old password:****
Enter a case-sensitive new password: ****
Enter the new password again for confirmation: ****
Success.
DGS-3000-26TC:admin