D-Link DGS-3000 series - Page 354

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
350
37-26 show jwac auth_state ports
Description
This command is used to display information for JWAC client hosts.
Format
show jwac auth_state ports {<portlist>}
Parameters
<portlist> - (Optional) Specifies a port range to show the JWAC authentication entries.
If no port is specified, the JWAC authentication state will be displayed for all ports.
Restrictions
None.
Example
To display JWAC authentication entries for ports 1 to 4:
DGS-3000-26TC:admin#show jwac auth_state ports 1-4
Command: show jwac auth_state ports 1-4
Pri - Priority. State - A:Authenticated, B:Blocked, -:Authenticating
Time - Aging Time/Idle Time for authenticated entries.
Port MAC Address State VID Pri Time IP User Name
----- -------------------- ---- ---- --- ------- --------------- ---------------
1 00-00-00-00-00-01 A 20 3 1440/30 192.168.101.239 jack
1 00-00-00-00-00-02 A 1234 - 1440/30 172.18.61.242 tom
1 00-00-00-00-00-03 B - - -/40 172.18.61.243 user
1 00-00-00-00-00-04 - - - 10 - -
2 00-00-00-00-00-10(P) A 1234 - 1440/30 10.10.10.90 admin
3 00-00-00-00-00-20(P) - - - 1440/30 10.10.10.131 -
3 00-00-00-00-00-21(P) B - - -/29 172.18.61.133 lina
4 00-00-00-00-00-21(P) A 1234 5 1440/30 3000:2000:3000:aabb:bbcc:ccdd:d
dee:eeff name
Total Authenticating Hosts : 2
Total Authenticated Hosts : 4
Total Blocked Hosts : 2
DGS-3000-26TC:admin#
37-27 config jwac authorization attributes
Description
This command is used to enable or disable acceptation of authorized configuration. When the
authorization is enabled for JWAC’s RADIUS, the authorized data assigned by the RADUIS server
will be accepted if the global authorization network is enabled. When the authorization is enabled
for JWAC’s local, the authorized data assigned by the local database will be accepted.