DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
366
passive - Specifies to set the LACP mode as passive.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To config port LACP mode:
DGS-3000-26TC:admin#config lacp_port 1-12 mode active
command: config lacp_port 1-12 mode active
Success.
40-7 show lacp_port
Description
This command is used to display the current mode of LACP of the ports.
Format
show lacp_por
t <portlist>
Parameters
lacp_port - Specifies a range of ports to be configured.
<portlist> - Enter the list of ports used for this configuration here.
If no parameter specified, the system will display current LACP and all port status.
Restrictions
None.
Example
To show port lacp mode:
To Next Page
Loading...
