DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
35
Format
disable gvrp
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the Generic VLAN Registration Protocol (GVRP):
DGS-3000-26TC:admin#disable gvrp
Command: disable gvrp
Success.
3-19 config private_vlan
Description
This command is used to add or remove a secondary VLAN from a private VLAN.
Format
config private_vlan [<vlan_name 32> | vid <vlanid 2-4094>] [add [isolated | community] |
remove] [<vlan_name 32> | vlanid <vidlist>]
Parameters
<vlan_name 32> - Specifies the name of the private VLAN.
vid - Specifies the VLAN ID of the private VLAN.
<vlanid 2-4094> - Enter the VLAN ID used here. This value must be between 2 and 4094.
add - Specifies that a secondary VLAN will be added to the private VLAN.
isolated - Specifies the secondary VLAN as isolated VLAN.
community - Specifies the secondary VLAN as community VLAN.
remove - Specifies that a secondary VLAN will be removed from the private VLAN.
<vlan_name 32> - Specifies the secondary VLAN name used. This name can be up to 32
characters long.
vlanid - A range of secondary VLAN to add or remove to the private VLAN.
<vidlist> - Enter the secondary VLAN ID used here.
Restrictions
Only Administrators and Operators can issue this command.
To Next Page
Loading...
