D-Link DGS-3000 series - Page 409

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
405
Example
To enable the MAC-based Access Control global state:
DGS-3000-26TC:admin#enable mac_based_access_control
Command: enable mac_based_access_control
Success.
DGS-3000-26TC:admin#
44-2 disable mac_based_access_control
Description
This command is used to disable MAC-based Access Control.
Format
disable mac_based_access_control
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the MAC-based Access Control global state:
DGS-3000-26TC:admin#disable mac_based_access_control
Command: disable mac_based_access_control
Success.
DGS-3000-26TC:admin#
44-3 config mac_based_access_control password
Description
This command is used to configure the RADIUS authentication password for MAC-based Access
Control.
Format
config mac_based_access_control password <passwd 16>