DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
407
44-5 config mac_based_access_control guest_vlan
Description
This command is used to assign a specified port list to the MAC-based Access Control guest
VLAN. Ports that are not contained in port list will be removed from the MAC-based Access
Control guest VLAN.
For detailed information on the operation of MAC-based Access Control guest VLANs, please see
the description for the “config mac_based_access_control ports” command.
Format
config mac_based_access_control guest_vlan ports <portlist>
Parameters
ports - Specifies MAC-based Access Control guest VLAN membership.
<portlist> - Enter the list of port used for this configuration here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the MAC-based Access Control guest VLAN membership:
DGS-3000-26TC:admin#config mac_based_access_control guest_vlan ports 1-8
Command: config mac_based_access_control guest_vlan ports 1-8
Success.
44-6 config mac_based_access_control ports
Description
This command is used to configure MAC-based Access Control port’s setting.
When the MAC-based Access Control function is enabled for a port and the port is not a MAC-
based Access Control guest VLAN member, the user who is attached to this port will not be
forwarded unless the user passes the authentication.
• A user that does not pass the authentication will not be serviced by the Switch.
• If the user passes the authentication, the user will be able to forward traffic operated under
the assigned VLAN.
When the MAC-based Access Control function is enabled for a port, and the port is a MAC-based
Access Control guest VLAN member, the port(s) will be removed from the original VLAN(s)
member ports, and added to MAC-based Access Control guest VLAN member ports.
To Next Page
Loading...
