DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
471
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an IGMP snooping multicast group profile with the name “test”:
DGS-3000-26TC:admin#create igmp_snooping multicast_vlan_group_profile test
Command: create igmp_snooping multicast_vlan_group_profile test
Success.
50-4 config igmp_snooping multicast_vlan_group_profile
Description
This command is used to configure an IGMP snooping multicast group profile on the Switch and
add or delete multicast addresses for the profile.
Format
config igmp_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcast_address_list>
Parameters
multicast_vlan_group_profile - Specifies the multicast VLAN profile name. The maximum
length is 32 characters.
<profile_name 1-32> - Enter the multicast VLAN group name here. This name can be up to
add - Adds a multicast address list to or from this multicast VLAN profile.
delete - Deletes a multicast address list to or from this multicast VLAN profile.
<mcast_address_list> - Enter the multicast VLAN IP address here. It can be a continuous single
multicast address, such as 225.1.1.1, 225.1.1.3, 225.1.1.8, a multicast address range, such as
225.1.1.1-225.2.2.2, or both of types, such as 225.1.1.1, 225.1.1.18-225.1.1.20.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add the single multicast address 225.1.1.1 to the IGMP snooping multicast VLAN profile named
“test”:
To Next Page
Loading...
