D-Link DGS-3000 series - Page 54

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
50
Format
delete 802.1x guest_vlan <vlan_name 32>
Parameters
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete the guest VLAN named “guestVLAN”:
DGS-3000-26TC:admin#delete 802.1x guest_vlan guestVLAN
Command: delete 802.1x guest_vlan guestVLAN
Success.
DGS-3000-26TC:admin#
4-19 config 802.1x guest_vlan
Description
This command is used to configure guest VLAN setting. If the specific port state is changed from
enabled state to disable state, this port will move to its original VLAN.
Format
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
Parameters
ports - A range of ports enable or disable guest VLAN function.
<portlist> - Enter the list of ports used for the configuration here.
all - Specifies that all the port will be included in this configuration.
state - Specifies the guest VLAN port state of the configured ports.
enable - Specifies to join the guest VLAN.
disable - Specifies to be removed from the guest VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Enable on port 2 to 8 to configure 802.1X guest VLAN: