D-Link DGS-3000 series - Page 558

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
554
allowed to receive. If the specified rate is not multiple of minimum granularity, the rate will
be adjusted.
Restrictions
Only Administrators can issue this command.
Example
To configure the ports 1-10 CoS bandwidth queue 1 min rate to 130 and max rate to 100000:
DGS-3000-26TC:admin#config per_queue bandwidth_control ports 1-10 1 min_rate
130 max_rate 1000
Command: config per_queue bandwidth_control ports 1-10 1 min_rate 130 max_rate
1000
Success.
DGS-3000-26TC:admin#
62-4 show per_queue bandwidth_control
Description
This command is used to display per port CoS bandwidth control settings.
Format
show per_queue bandwidth_control {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.
If no parameter is specified, system will display all ports CoS bandwidth configurations.
Restrictions
None.
Example
Display per port CoS bandwidth control table: