D-Link xStack DGS-3620 Series - Page 888

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
883
The authentication procedure for time transfer require that both the local and remote NTP servers
employ the same key ID and secret for this purpose.
Format
config ntp trusted_key <key_id>
Parameters
<key_id> - Enter the key ID to be trusted for the purposes of authenticating peers with symmetric
key cryptography.
Restriction
Only Administrators, Operators and Power Users can issue this command.
Examples
To configure a trusted key:
DGS-3620-28PC:admin# config ntp trusted_key 42
Command: config ntp trusted_key 42
Success.
DGS-3620-28PC:admin#
76-16 config ntp update-calendar state
Description
This command is used to enable or disable the periodical updating of the hardware clock (calendar)
from an NTP time source.
Format
config ntp update-calendar state [enable | disable]
Parameters
enable - Specifies to enable the periodical updating.
disable - Specifies to disable the periodical updating.
Restriction
Only Administrators, Operators and Power Users can issue this command.
Examples
To periodically update the hardware clock from the NTP time source: